Ford tsb lookup manual#

It is fully backwards compatible and is strongly recommended for all applications that currently require the specification WSS-M2C913-B.

Ford tsb lookup manual#

This bulletin has been produced to eliminate any confusion and make sure that the Workshop Manual Sections on FordEtis and Labour Times Schedule (LTS) are aligned.Ġ8/06/09 New Oil Specification - WSS-M2C913-CĪ new engine oil with the specification WSS-M2C913-C has been released. Failure to adhere these instruction will result in warranty claims being rejected. Make sure that both pre and post test results are captured when wheel alignment is checked and toe settings are adjusted. If the tie rod end or the lower arm ball joint was only disconnected from the wheel knuckle, NO check of the toe setting is required. Any unrelated procedure which requires the front or rear crossmember to be moved, should also include a check of the relevant toe setting at the conclusion of the repair. If a procedure is NOT listed in the tables in this bulletin, then there is NO requirement to check or adjust the toe setting as part of that particular procedure. The selection of the labor operation number for the toe/wheel alignment check depends on the equipment available at the dealership. This bulletin contains information for Dealers and Warranty Claims analysts on the Workshop Manual Section procedures on FordEtis where there IS a requirement to include the check/adjust of the toe setting as part of that procedure. With the windshield cleaner listed under with finis code: 1 374 231 or 1 374 232, silicone residues can also be removed from the inside of the windshield. Do not mix different windshield washer concentrate products. Only Ford original spare parts fulfill the stipulated requirements. This TSB includes a wiper blade and wiper blade contact angle check using special tools 501-027 / 501-027-01Īs the composition of vehicle window glass is different to that of normal window glass, household cleaners should not be used. Particularly in new vehicles, the concern may be caused by residues of the wax coating applied during production, which is removed over time.įurther to this, if a new windshield glass or rear window glass is installed, or if the wiper arms are removed and installed, the wiper arm angle should be checked and adjusted according to the instructions in this bulletin. Should a customer express concern about the wiper blades juddering, noisy and not cleaning properly during operation, the probable cause is a dirty windshield glass / rear window glass, defective / worn wiper blades or an incorrect wiper arm angle.

Just checked for you mate says exactly the same as mineġ6/12/09 Windshield wiper blades juddering, smearing, noisy and not cleaning properly I could then add it to a thread I am working on with regard to water leak I've got on the door. I am sure it will only say the three small things like wiper blades, and oil type as totalguy said.